Abstract
The topic of this publication is the reconstruction and measuring process of a used straight spur gear. The tooth number, the tip circle diameter and the tooth length have to be measured for the reconstruction. Based on these parameters the type of the straight spur gear has to be determined. For the designing of the gear a new computer program is created. Based on the calculated parameters the CAD model of the gear could be designed. The profile of the real spur gear is measured by a microscope having computer controlled. The real and the theoretical involute profile curve will be analysed.
Highlights
The aim of the publication is the reconstruction and measuring process of a straight spur gear
The first step of the reconstruction is the determination of the standard module
The main parameters of a connecting gear pairs could be seen on Figure 1 and Table 1
Summary
1. Introduction The aim of the publication is the reconstruction and measuring process of a straight spur gear. The module is the basic parameter of a spur gear [2, 4, 5, 6, 7]. The main parameters of a connecting gear pairs could be seen on Figure 1 and Table 1. Nomination Dedendum Addendum Whole depth Circular pitch Tooth thickness Modulee Number of teeth Backlash Base profile angle Tooth thickness along working pitch circle
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.