Reconstruction and hydration of hydrotalcite response to thermal activation temperature: Enhancement of properties for magnesia castables

Abstract

Optimization binding system for refractory castables is significant to enhance the service performance. Hydrotalcite has been considered a promoter for high-temperature performance of basic castables, however, its binding property remains to be improved before practical application. In this work, the thermal activated Mg–Al hydrotalcites were incorporated in magnesia castables, and the mutual influence of pre-calcination temperature on the hydration, microstructure, and strength of castables was investigated. The obtained results indicated that the reconstruction of calcined hydrotalcite took place in the hydration process and effectively motivated the hydrolysis. Hydrate was thus promoted and a relatively dense microstructure of magnesia castables was confirmed by X-ray computed tomography analysis. Hydrotalcite pre-calcinated at 300 °C contributed to the highest early strength for castable, and the high-temperature properties also performed better than that of other pre-calcinated hydrotalcite-adding. The enhancement mechanisms of calcined hydrotalcite were attributed to the two following reasons: (ⅰ) the modified microstructure of magnesia castables from the early stage by hydration process, (ⅱ) the further enhanced sinterability inspired by the appropriate thermal activation effect.