Abstract
Original volcanic edifices of two successive stages of Gran Canaria are reconstructed using a geomorphometric analysis of existent or restored paleosurfaces. In the reconstruction, surface fitting was applied preferably to planèzes (i.e. triangular facets of original volcano flanks) and quasi-planar surfaces, QPS (those occurring on planèzes, or scattered, slightly eroded portions derived from original cone surfaces) with the help of red relief image map (RRIM) analysis. Out of the long-lasting, Mid-Miocene to Holocene subaerial evolution of the island, the Late Miocene Fataga volcano and the subsequent, Pliocene Roque Nublo volcanoes were the largest and highest. The eruptive center of Fataga, a composite edifice (12.2–8.8Ma) that may have grown up excentrically with respect to the previous Tejeda caldera, is well-defined by both two planèzes (named Veneguera–Mogán and Fataga–Tirajana) and QPS remnants. Its calculated original volume, ≤1000km3, is close to the largest stratovolcanoes on Earth. However, its ≥3300m elevation, obtained by exponential fit, may have been significantly lower due to the complex architecture of the summit region, e.g. a caldera responsible for ignimbrite eruptions. Roque Nublo, a 3.7–2.9Ma stratovolcanic cone, which was superimposed upon the Fataga rocks ≥3km west of the Fataga center, has left no considerable paleosurfaces behind due to heavy postvolcanic erosion. Yet, its remnant formations preserved in a radial pattern unambiguously define its center. Moreover, surface fitting of the outcropping rocks can be corrected taking the erosion rate for the past 3Ma into account. Such a corrected surface fit points to a regular-shaped, ≥3000m-high cone with a 25km radius and ca. 940km3 original volume, also comparable with the dimensions of the largest terrestrial stratovolcanoes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.