Abstract
Abstract High-performance engineering polymers are a potential frictional material candidate for mechanical systems with moving parts, especially at high load and speed conditions. In this study, reciprocating friction and wear of aramid fibers/polyimide composites filled with graphite, MoS2 or Polytetrafluoroethylene, respectively, were systematically investigated on a Pin-on-Flat test rig. The experimental setup was simplified into friction materials reciprocating against a phosphor bronze pin to simulate the rotor/stator contact state in ultrasonic motors. A comparative study on friction reduction and wear resistance of polyimide composites indicated that graphite showed the best lubricity with low friction coefficient and wear rate. Experimental results of pressure time average velocity measurements showed that frequencies ranging from 3 to 11 Hz played a significant role on the friction coefficient variations of these porous polyimide composites, whereas increasing pressure from 4 to 6 MPa had little effect on friction reduction. Then, the microstructure of the worn surface of the three different materials was observed by scanning electron microscope to reveal the wear mechanisms. This study is expected to provide a good guidance for porous polyimide composites application in ultrasonic motors.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
