Reasonable location of stopping line in close-distance underlying coal seam and partition support of large cross-section roadway

Abstract

Close-distance coal seams are widely distributed over China, and the coal pillars left by the overlying coal seams affect the retracement channel of the underlying coal seam in the stopping stage. Based on the engineering background of close-distance seam mining in a coal mine, the reasonable position of the underlying coal seam's stopping line and the support method of the large section roadway during stopping are investigated using field measurements, similar simulation experiments, and numerical simulations. There are three types of location relationships between the stopping line of the underlying coal seam and the stopping line of the overlying coal seam: "externally staggered with the upper stopping line" (ESUL, stops mining under the overlying goaf), "overlapped with upper stopping line" (OUL), and "internally staggered with the upper stopping line" (ISUL, ISUL-SD for shorter internal staggered distances, ISUL-LD for longer ones). There are different stress arch structures in the overlying strata of the above three positions, and the stress arch evolution process exists in the process of ESUL → OUL → ISUL-SD → ISUL-LD: a front and rear double stress arch structure → the front arch gradually decreases → the front arch dies out, and the double arch synthesizes the single arch → the single-arch range expands → the nested double arch. The relationship between the stress arch structure and the position of the stopping line is evaluated as follows: (1) ESUL: the stress concentration in the roof plate of the retracement channel of the underlying coal seam is the highest, because the overburden block of the extensive collapse zone acts directly on the roof plate of the retracement channel, resulting in relative difficulties in roof support. (2) OUL: although the retracement channel roof pressure is minimal, the overlying rock structure has the potential for rotation or slippage instability. (3) ISUL-SD: the pressure on the roof of the retracement channel is small and the overburden structure is stable, which is conducive to the safe retraction of the support and not limited by the width of the end-mining coal pillar. (4) ISUL-LD: it is basically the same as the condition of stopping under the non-goaf; however, it has a limitation on the width of the end-mining coal pillar. The location of the stopping line is selected as ISUL-SD, and the retraction process of the self-excavating retraction channel was adopted. A partition asymmetric support scheme which is proven by field practice is proposed, through a comprehensive analysis of the pre-stress field simulation of the support scheme, based on the different control requirements of the roof above the support and the roof of the retracement channel in the stopping area. This method realizes safe and smooth withdrawal of the support.