Abstract
The advance in power electronics causes, over the years, an increasing diffusion of nonlinear loads. Moreover, electrical generation systems are going to include a growing amount of solar and wind energy, characterized by time-variant flow of energy and, very often, with a relevant distortion. These aspects give more and more emphasis to the monitoring of conducted disturbances on power systems over a wide frequency range, and consequently, voltage and current transducers adopted for this aim must have a proper frequency bandwidth. Voltage transformers (VTs) and current transformers (CTs), which are the most installed transducers in electrical power systems, are typically constructed to operate only at the industrial frequency, i.e., 50/60 Hz, but it is clear that their substitution would require an unsustainable cost. Therefore, in this paper, a method for real-time digital compensation of the CT frequency response over a wide range is presented. An implementation of the proposed method is shown, and the compensated CT is characterized and tested in some practical situations, with waveforms affected by typical power quality disturbances.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
