Abstract
To solve the problems of motor's data acquisition system's low automation level, too less data channel, limited apply areas. This paper introduced a kind of motor's data acquisition and analyzation system which were developed based on producer/consumer model and LabVIEW program. This system can fulfil the tasks of multi-channel data acquisition, data analyzation and display, data saving and loading. By setting two different data acquiring frequencies, that's 2kHz and 20kHz, to acquire the same signal that produced by the signal generator and analyzing the data that were acquired. According to the analysis and data fitting results the benefits and short comes was concluded. These tests suggested that the signal can be represented by this two kind of data acquiring frequency and the standard error that the 2kHz had is bigger than that of 20kHz had. So, the test's result proved that this system works well and easy to realize.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.