Real-time Reconstruction of Comminuted Mandibular Fractures Using 3D Printing.

Abstract

Comminuted fractures of the jaws are complex injuries requiring special attention. In the past, treatment included closed reduction using maxillomandibular fixation. With advancements in technology and fixation systems, open reduction became a prevalent option. These fractures are difficult to reconstruct during the primary treatment phase, thus resulting in higher complication rates. The introduction of three-dimensional (3D) planning and printing brought about superior outcomes, yet these focus on secondary reconstruction due to the need for outsourcing planning and titanium printing. In this report, we describe real-time in-house 3D planning and printing using computer-assisted design software and a 3D-fused deposition printer for virtual reduction of the comminuted fractures and printing of the reconstructed mandible. Following virtual 3D reduction, the newly created mandibles were 3D printed. The model was then used to preband a reconstruction plate, which in turn was used as a template during surgery for reducing the segments. The process of virtual reduction and printing should take a couple of hours at most. The results of five cases showed good alignment and proper function. Three-dimensional technology can be applied in the everyday primary care treatment protocol of comminuted fractures as an in-house tool which greatly improves both functional and aesthetic outcomes.