Real time observation of crystallization in polyethylene oxide with video rate atomic force microscopy

Abstract

Video rate atomic force microscopy (VideoAFM), with a frame rate of 14 frames/s and a tip velocity of up to 15 cms −1, is used to image polyethylene oxide films during crystal growth. The capabilities of VideoAFM when applied to semicrystalline polymer surfaces are explored. Image quality comparable to that found with conventional contact AFM is achieved but with a nearly 1000 times improvement in time resolution. By applying the technique to the real-time observation of crystal growth, different modes of rapid crystallization are followed in real time. Observation of the spherulite growth front allows measurement of growth rates at the lamellar scale, from which a factor of two difference in the rate of radial growth to the rate of tangential growth is observed, confirming that the elongated nature of spherulite lamellae is due to geometric constraints rather than an inherent fibrillar character. Measurements on screw dislocation growth, when large amounts of crystallizable material is trapped at the surface show that the terrace height does not influence the rate of crystal growth, confirming that under these conditions processes at the lamellar growth front control the rate of growth. When only a thin film of molten material is left on the surface of the already crystallized film dendritic growth is observed, implying a diffusion controlled process under these far from equilibrium conditions.