Readout Electronics for CEPC Semidigital Hadron Calorimeter Preprototype

Abstract

Circular Electron and Positron Collider (CEPC) is a large experiment facility proposed by the Chinese particle physics community. One of the running options is being the Higgs factory. The calorimeter is the main part of this experiment to measure the jet energy. Semidigital hadron calorimeter (SDHCAL) is one of the options for the hadron measurement. Gas electron multiplier (GEM) detector with its high-position resolution and flexible configuration is one of the candidates for the active layer of the SDHCAL. The main purpose of this paper is to provide a feasible readout method for the GEM-based SDHCAL. A smallscale prototype is designed and implemented, including front-end board (FEB) and data interface board (DIF). The prototype electronics has been tested. The equivalent rms noise of all channels is below 0.35 fC. The dynamic range is up to 500 fC and the gain variation is less than 1%. The readout electronics is applied on a double-layer GEM detector with 1 cm × 1 cm readout pad. The result indicates that the electronics works well with the detector. The detection efficiency of minimum ionization particle (MIP) is over 95% with a 5-fC threshold.