Abstract
Abstract Reactively thermal sprayed coatings based on in-process reactions during flight and after impingement offer superior properties compared with conventional coatings because it has in-situ formed fine and uniformly dispersed stable hard phases. In the present work, composite powder composed of plated nickel, fine SiO2 particulates and Al-Si-Mg core particles with water glass binder (SiO2/Ni/Al-Si-Mg) was deposited onto an aluminum substrate to fabricate composite coatings by using HVOF (high velocity oxyfuel), RF (radio frequency) and DC (direct current) plasma spraying methods. The amount and constituents of phases formed during reactive thermal spraying were found to be different depending upon the methods used where in-process reactions differently proceed. Consequently, reactively sprayed composite coatings mainly consist of Mg2Si, MgAl2O4, NiAl3 and Al-Si matrix through the exothermic reaction of SiO2 and nickel with molten Al-Si-Mg alloy. The depletion of magnesium in the composite powder is responsible for the obtained lower hardness of composite coatings sprayed by RF plasma spraying which offers the highest molten droplet temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
