Abstract
According to the feature of Mg–Zn eutectic reaction, Al alloy was bonded to Mg alloy by contact reaction brazing using a zinc-based brazing alloy successfully. The experimental observations showed that Mg–Al intermetallic compounds were avoided for the addition of the zinc-based brazing alloy. The Mg substrate and the remanent brazing alloy were bonded with the reaction zone that formed along the zinc rich and magnesium poor interface. Only a few Mg–Zn intermetallic compounds (MgZn2) existed homogeneously in the reaction zone. The substrate and the remanent brazing alloy were bonded with a thin Al–Zn solution. The average tensile-shear strength of the final joints was a little lower than that of the zinc-based brazing alloy owning to some pores at the interface between the reaction zone and the remanent brazing alloy layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
