Rapid Removal of Organics and Oil Spills from Waters Using Silicone Rubber “Sponges”

Abstract

We have developed a simple, robust, and efficient technology utilizing cheap and recoverable materials based on commercially available silicone elastomer networks for removing organic solvents and crude oil from waters. Hydrophobic and oleophilic properties of silicone elastomers endow poly(dimethyl siloxane) (PDMS) with the capacity to absorb a large variety of organics, including benzene (B), toluene (T), ethylbenzene (E), and xylene (X), commonly referred to as BTEX, and also crude oils, while at the same time enabling the organic “sponges” to float on waters, which facilitates straightforward handling. We developed a method for generating PDMS particles with variable sizes (ranging from hundreds nanometers to few millimeters) by drop-wise depositing siloxane/cross-linker mixtures into warm water, a process which leads to the cross-linking of the PDMS components. We have tested the capability of the PDMS particles to remove toluene and benzene from water. We also performed similar experiments by utilizing PDMS sheets. In both instances we observed a rapid sorption of the organic phase into PDMS; the amount of absorbed organic solvent depended on the concentration in water and the total mass (volume) of PDMS and did not depend on the geometry of the PDMS “sponge.” In addition, we have examined the uptake of toluene and benzene from toluene/benzene (T/B) mixtures dissolved in water. Our results indicate that the amount of benzene absorbed from the T/B mixtures into PDMS increases relative to the uptake from pure benzene/water solutions. This behavior is associated with toluene acting as a “surfactant” that effectively replaces the more unfavorable PDMS/B contacts with less costly T/B ones. Finally, a simple experiment demonstrates qualitatively that PDMS is also capable of removing crude oils from oil-contaminated waters.