Abstract
Sample preparation and scanning electron microscopy imaging methods were developed to characterize solid‐oxide fuel cell anodes made out of a nickel–yttria‐stabilized zirconia porous cermet. The sample preparation uses only tripod polishing and does not require any resin impregnation. To overcome surface damages induced by polishing, as well as to increase contrast between phases, high acceleration voltages were used. The method gave results of a small systematic increase of the measured nickel proportion due to imaging conditions. A quick image analyzing method is also presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.