Rapid Photoacoustic Exhaust Gas Analyzer for Simultaneous Measurement of Nitrogen Dioxide and Sulfur Dioxide.

Abstract

A rapid photoacoustic (PA) exhaust gas analyzer is presented for simultaneous measurements of nitrogen dioxide (NO2) and sulfur dioxide (SO2). A laser diode (LD) emitting at 450 nm and a light-emitting diode (LED) with a peak wavelength of 275 nm operated simultaneously, producing PA signals of NO2 and SO2, respectively. The LD and LED were modulated at different frequencies of 2568 and 2570 Hz, and their emission light beams were transmitted through two resonant tubes in a differential PA cell (DPAC), respectively. A self-made dual-channel digital lock-in amplifier was used to realize the simultaneous detection of dual-frequency PA signals. Cross interference between the PA signals at the two different frequencies was reduced to 0.02% by using a lock-in amplifier. In order to achieve a rapid dynamic measurement, gas sampling was accelerated by an air pump. The use of mufflers and the differential PA detection technique significantly reduced the gas sampling noise. When the gas flow rate was 1000 sccm, the response time of the PA dual-gas analyzer was 8 and 17 s for NO2 and SO2, respectively. The minimum detection limits of NO2 and SO2 were 1.7 and 26.1 ppb when the averaging time of the system was 10 s, respectively. Due to the wide spectral bandwidth of the LED, NO2 produced an interference to the detection of SO2. The interference was reduced by the precise detection of NO2. Since the radiations of the LD and LED passed through two different PA tubes, the impact of NO2 photochemical dissociation caused by UV LED luminescence on NO2 gas detection was negligible. The sharing of the PA cell, the gas lines, and the signal processing modules significantly reduced the size and cost of the PA dual-gas analyzer.