Abstract

AbstractThe rapid thermal annealing of doped (SOD) and undoped (SOG) glass films spinned onto silicon from diluted or undiluted solutions has been investigated. The dilution performed by methanol has allowed to obtain oxide films as thin as 10 nm.The optical measurements of annealed SOG films have shown that good oxide films without oxygen deficiency are achievable. The electrical characteristics of Al-gate capacitors assessed by Capacitance-voltage measurements have shown a great dependence of the water content in the range of 600–850°C before reaching a typical dielectric constant value near 3.8 at higher temperatures. Low Interface state densities values obtained at temperature up to 900°C confirm the curing effect of a rapid thermal annealing.On the other hand, we have demonstrated that the efficiency of rapid thermal diffusion from boron or phosphorus SOD films deposited on Si wafers depends on the source composition and its thickness. In particular, we have shown that it is possible to control the junction depth, the surface concentration and the minority-carrier diffusion length by varying the amount of dopant concentration in the solution, the thickness of the doped oxide film and the rapid thermal processing parameters. Futhermore, the remaining doped SOG film can play the role of an efficient oxide passivation layer.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.