Raman Microspectroscopic Study on Polymerization and Degradation Processes of a Diacetylene Derivative at Surface Enhanced Raman Scattering Active Substrates. 1. Reaction Kinetics

Abstract

Raman microspectroscopy was applied to study the polymerization kinetics of the Langmuir-Blodgett (LB) films of 10,12-pentacosadiynoic acid (DA) adsorbed on surface enhanced Raman scattering (SERS) active Ag island films. A two-dimensional (2D) Raman microscopic image measured at 1520 cm(-1) exhibits bright and dim spots with the diameter of several hundred nanometers. Raman microscopic spectra, measured by defocusing the excitation laser light (532 nm, diameter of ca. 10 mum) on the samples at room temperature, proved the occurrence of the surface processes consisting of the formation of polydiacetylene (PDA) in the blue phase, its conversion to the red phase, and subsequent bleaching. These reactions were negligible under the same condition for the DA-LB films prepared on a smooth (i.e., SERS-inactive) Ag film, indicating that the 532-nm-induced polymerization and the bleaching process are enhanced by the SERS-active substrates. At low temperatures below -50 degrees C, the Raman microscopic measurements proved the formation of the blue phase and its conversion to the red phase with much lower reaction rates compared to the corresponding rates at room temperature. The bleaching, however, was much suppressed at the low temperatures. The kinetic analyses of the formation of the blue phase and its conversion to the red phase were performed by using the intensity changes of the Raman bands due to the blue (1477 cm(-1)) and red (1517 cm(-1)) phases as a function of the irradiation time. The results strongly suggested the existence of at least two processes taking place simultaneously on the SERS-active substrates; that is, one of the processes is a sequential reaction, DA-monomers --> PDA in the blue phase --> PDA in the red phase, and the other is another sequential reaction, DA-monomers --> PDA in the red phase --> degradation species (probably amorphous carbon). Thus, even at the low temperatures, there occurs the surface reaction consisting of the formation of PDA and its degradation. The reaction can be ascribed to a process taking place at the highly SERS-active site, which gives the bright spot (so-called "hot spot") on the 2D Raman image, as proved by the confocal Raman microscopic measurement in the following paper.