Abstract
Damage to the surface of railway wheels and rails commonly occurs in most railways. If not detected, it can result in the rapid deterioration and possible failure of rolling stock and infrastructure components causing higher maintenance costs. This paper presents an investigation into the modelling and simulation of wheel-flat and rail surface defects. A simplified mathematical model was developed and a series of experiments were carried out on a roller rig. The time–frequency analysis is a useful tool for identifying the content of a signal in the frequency domain without losing information about its time domain characteristics. Because of this, it is widely used for dynamic system analysis and condition monitoring and has been used in this paper for the detection of wheel flats and rail surface defects. Three commonly used time–frequency analysis techniques: Short-Time Fourier Transform, Wigner–Ville transform and wavelet transform were investigated in this work.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
