Radon-222 activity flux measurement using activated charcoal canisters: Revisiting the methodology

Abstract

The measurement of radon (222Rn) activity flux using activated charcoal canisters was examined to investigate the distribution of the adsorbed 222Rn in the charcoal bed and the relationship between 222Rn activity flux and exposure time. The activity flux of 222Rn from five sources of varying strengths was measured for exposure times of one, two, three, five, seven, 10, and 14 days. The distribution of the adsorbed 222Rn in the charcoal bed was obtained by dividing the bed into six layers and counting each layer separately after the exposure. 222Rn activity decreased in the layers that were away from the exposed surface. Nevertheless, the results demonstrated that only a small correction might be required in the actual application of charcoal canisters for activity flux measurement, where calibration standards were often prepared by the uniform mixing of radium (226Ra) in the matrix. This was because the diffusion of 222Rn in the charcoal bed and the detection efficiency as a function of the charcoal depth tended to counterbalance each other.The influence of exposure time on the measured 222Rn activity flux was observed in two situations of the canister exposure layout: (a) canister sealed to an open bed of the material and (b) canister sealed over a jar containing the material. The measured 222Rn activity flux decreased as the exposure time increased. The change in the former situation was significant with an exponential decrease as the exposure time increased. In the latter case, lesser reduction was noticed in the observed activity flux with respect to exposure time. This reduction might have been related to certain factors, such as absorption site saturation or the back diffusion of 222Rn gas occurring at the canister–soil interface.