Abstract

Obtaining the in-depth information of radioactive contaminants is crucial for determining the most cost-effective decommissioning strategy. The main limitations of a burial depth analysis lie in the assumptions that foreknowledge of buried radioisotopes present at the site is always available and that only a single radioisotope is present. We present an advanced depth estimation method using Bayesian inference, which does not rely on those assumptions. Thus, we identified low-level radioactive contaminants buried in a substance and then estimated their depths and activities. To evaluate the performance of the proposed method, several spectra were obtained using a 3 × 3 inch hand-held NaI (Tl) detector exposed to Cs-137, Co-60, Na-22, Am-241, Eu-152, and Eu-154 sources (less than 1μCi) that were buried in a sandbox at depths of up to 15 cm. The experimental results showed that this method is capable of correctly detecting not only a single but also multiple radioisotopes that are buried in sand. Furthermore, it can provide a good approximation of the burial depth and activity of the identified sources in terms of the mean and 95% credible interval in a single measurement. Lastly, we demonstrate that the proposed technique is rarely susceptible to short acquisition time and gain-shift effects.

Highlights

  • Sites near nuclear power plants are susceptible to large-scale land and building contamination because of the significant amount of radioactive waste generated by such facilities

  • Energy calibration was radioisotopes analyzed for a spectrum, measured for 300 s for a Cs-137 source buried at a depth of 3 performed to taking each measurement viathat the the built-in automatic calibration provided cm

  • We found that the proposed technique was capable of correctly identifying the buried radioisotopes and determining the depth of the identified radioisotopes with the exception of the Am-241 source at burial depths exceeding 9 cm

Read more

Summary

Introduction

Sites near nuclear power plants are susceptible to large-scale land and building contamination because of the significant amount of radioactive waste generated by such facilities. The task of depth profiling is still difficult to achieve because porous materials such as soil and concrete covering the contaminants can act as a shield, resulting in the attenuation of emitted radiation. One example of such waste is on the beaches of Dounreay in Northern Scotland, where radioactive soil contaminants are widely spread along the beach [5,6].

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.