Radiographic evaluation of alveolar ridge preservation using a chitosan/polyvinyl alcohol nanofibrous matrix: A randomized clinical study

Abstract

The objective of this randomized clinical trial (RCT) was to assess the effectiveness of electrospun chitosan/polyvinyl alcohol (CS/PVA) nanofibrous scaffolds in preserving the alveolar ridge and enhancing bone remodeling following tooth extraction when compared to a control group. In this split RCT, 24 human alveolar sockets were randomly assigned to two groups, with 12 sockets receiving CS/PVA nanofibrous scaffold grafts (test group) and 12 left to heal by secondary intention as the control group. Cone-beam computed tomography (CBCT) was performed at two different time points: immediately after extraction (T0) and 4 months post-extraction (T4). After 4 months, linear vertical and horizontal radiographic changes and bone density of extraction sockets were assessed in both the test and control groups. The RCT included 12 patients (4 male and 8 female) with a mean age of 24 ± 3.37 years. The test group had a significantly lower mean vertical resorption vs the control group, with a mean difference of 1.1 mm (P < 0.05). Similarly, the control group's mean horizontal bone resorption was −2.01 ± 1.04 mm, while the test group had a significantly lower mean of −0.69 ± 0.41 mm, resulting in a mean difference of 1.35 mm (P < 0.05). Furthermore, the study group exhibited a significant increase in bone density (722.03 ± 131.17 HU) after 4 months compared to the control group (448.73 ± 93.23 HU). In conclusion, we demonstrated within the limitations of this study that CS/PVA nanofibrous scaffold significantly limited alveolar bone resorption horizontally and vertically and enhanced bone density in alveolar sockets after 4 months when compared to results in the control group (TCTR20230526005).