Abstract

Abstract. While several studies have investigated winter-time air pollution with a wide range of concentration levels, hardly any results are available for longer time periods covering several winter-smog episodes at various locations; e.g., often only a few weeks from a single winter are investigated. Here, we present source apportionment results of winter-smog episodes from 16 air pollution monitoring stations across Switzerland from five consecutive winters. Radiocarbon (14C) analyses of the elemental (EC) and organic (OC) carbon fractions, as well as levoglucosan, major water-soluble ionic species and gas-phase pollutant measurements were used to characterize the different sources of PM10. The most important contributions to PM10 during winter-smog episodes in Switzerland were on average the secondary inorganic constituents (sum of nitrate, sulfate and ammonium = 41 ± 15%) followed by organic matter (OM) (34 ± 13%) and EC (5 ± 2%). The non-fossil fractions of OC (fNF,OC) ranged on average from 69 to 85 and 80 to 95% for stations north and south of the Alps, respectively, showing that traffic contributes on average only up to ~ 30% to OC. The non-fossil fraction of EC (fNF,EC), entirely attributable to primary wood burning, was on average 42 ± 13 and 49 ± 15% for north and south of the Alps, respectively. While a high correlation was observed between fossil EC and nitrogen oxides, both primarily emitted by traffic, these species did not significantly correlate with fossil OC (OCF), which seems to suggest that a considerable amount of OCF is secondary, from fossil precursors. Elevated fNF,EC and fNF,OC values and the high correlation of the latter with other wood burning markers, including levoglucosan and water soluble potassium (K+) indicate that residential wood burning is the major source of carbonaceous aerosols during winter-smog episodes in Switzerland. The inspection of the non-fossil OC and EC levels and the relation with levoglucosan and water-soluble K+ shows different ratios for stations north and south of the Alps (most likely because of differences in burning technologies) for these two regions in Switzerland.

Highlights

  • Ambient particulate matter (PM) influences the Earth’s climate directly by scattering and absorbing solar radiation and indirectly by modifying cloud microphysics (Pöschl, 2005; IPCC, 2013)

  • The reason for the higher PM10 values at stations south of the Alps is most likely due to a combination of topography, local meteorology and emissions

  • In this study we present source apportionment results of winter-smog episodes in Switzerland using radiocarbon (14C) analysis separated for the elemental (EC) and organic (OC) carbon fraction together with levoglucosan, major water-soluble ionic species and gas phase pollutant measurements

Read more

Summary

Introduction

Ambient particulate matter (PM) influences the Earth’s climate directly by scattering and absorbing solar radiation and indirectly by modifying cloud microphysics (Pöschl, 2005; IPCC, 2013). Environmental pollution control strategies and policies have focused mainly on emissions from fossil fuel combustion so far (e.g., road traffic and industry). Many recent studies have shown that wood burning emissions from domestic heating can be the dominating source of carbonaceous aerosols during the cold season, in Europe (e.g., Szidat et al, 2006, 2007; Lanz et al, 2008, 2010; Favez et al, 2010; Gilardoni et al, 2011; Harrison et al, 2012; Herich et al, 2014 and references therein). The quantification of the fossil and non-fossil, especially wood burning, contributions to PM, for days with high PM concentrations, is crucial for establishing effective mitigation strategies

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call