Abstract

Synthetic aperture radar (SAR) is susceptible to radio frequency interference (RFI), which becomes especially commonplace in the increasingly complex electromagnetic environments. RFI severely detracts from SAR imaging quality, which hinders image interpretation. Therefore, some RFI mitigation algorithms have been introduced based on the partial features of RFI, but the RFI reconstruction models in these algorithms are rough and can be improved further. This paper proposes two algorithms for accurately modeling the structural properties of RFI and target echo signal (TES). Firstly, an RFI mitigation algorithm joining the low-rank characteristic and dual-sparsity property (LRDS) is proposed. In this algorithm, RFI is treated as a low-rank and sparse matrix, and the sparse matrix assumption is made for TES in the time–frequency (TF) domain. Compared with the traditional low-rank and sparse models, it can achieve better RFI mitigation performance with less signal loss and accelerated algorithm convergence. Secondly, the other RFI mitigation algorithm, named as TFC-LRS, is proposed to further reduce the signal loss. The TF constraint concept, in lieu of the special sparsity, is introduced in this algorithm to describe the structural distribution of RFI because of its aggregation characteristic in the TF spectrogram. Finally, the effectiveness, superiority, and robustness of the proposed algorithms are verified by RFI mitigation experiments on the simulated and measured SAR datasets.

Highlights

  • In the last few decades, a more complex electromagnetic environment has been formed due to the increasing number of electromagnetic devices, leading to more mutual influence among electromagnetic signals [1,2]

  • The performances of low-rank characteristic and dual-sparsity property (LRDS) and TFC-LRS are compared with those obtained by instantaneous-spectrum notch filtering (ISNF) [12], Eigenspace projection (ESP) [19], and go decomposition (GoDec) [33]

  • The simulated single snapshot was generated by applying radio frequency interference (RFI) with an interference-to-signal ratio of −10 dB to a measured Synthetic aperture radar (SAR) echo signal collected without interference by an X-band airborne SAR

Read more

Summary

Introduction

In the last few decades, a more complex electromagnetic environment has been formed due to the increasing number of electromagnetic devices, leading to more mutual influence among electromagnetic signals [1,2]. The signals from other electromagnetic devices detracting from the target echo signal (TES) are defined as radio frequency interference (RFI), which can be divided into narrowband interference (NBI) and wideband interference (WBI) by the band ratio of interference to signal (usually set as 1%) [3]. RFI has a stronger power than TES, and its presence can significantly reduce the signal-to-noise ratio (SNR) of the SAR echo, and even lead to receiver saturation. RFI generates inaccuracies in the estimation of critical Doppler features, such as the centroid and modulation rates, resulting in blurry SAR images [6,7,8]. Substantial efforts should be dedicated to the research of RFI detection and mitigation for preserving the precious SAR data

Objectives
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call