Abstract
The probability of antenna array failure or malfunctioning cannot be ruled out, and hardware replacement of faulty elements is not always a viable solution. Therefore, academic and industrial interest in self-healing phased arrays are on the rise. In this work, the phase-only genetic algorithm (GA) optimization flow for the radiation pattern correction of a 4 × 4 phase faulty planar antenna array is proposed. Initially, a reference array pattern at the desired scan angle is generated. Then random phase faults are introduced across the 1 × 4 antenna elements in any one of 4 sub-arrays to produce maximum distortion in the reference radiation pattern of 4 × 4 planar array. The proposed GA re-computes the new excitation weights for the remaining non-faulty 3 sub-arrays to correct the overall radiation pattern of 4 × 4 array. This is achieved by calculating the array output power for reference and GA computed weights. The GA corrected patterns fairly follow the desired array patterns in terms of peak gain and reducing sidelobe levels for the desired scan angle. The efficiency of the optimized radiation patterns was evaluated in full-wave HFSS model and measurements validation. In this way, maintenance cost can be reduced with recovery of acceptable level of radiation pattern using software instead of physically replacing faulty antenna elements in the array.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.