Abstract
The development of solid-state control and switching has been a boom to the electrical and electronic circuit designer but has proved to be a problem to those concerned with the interconnection of the "black box" and its associated equipment. Careful attention given to proper wire selection and to installation procedures will largely eliminate that noise which might otherwise cause equipment failure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Industry and General Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.