Quantitative tooth wear analysis of index teeth compared to complete dentition

Abstract

ObjectivesRecent software advancements have facilitated quantification of erosive tooth wear progression using intraoral scans. This paper investigated if wear on commonly affected surfaces (central incisors and first molars) was representative of wear on the full arch. MethodsBimaxillary digital intraoral scans (True Definition, 3 M, USA) of patients (n = 30) from the monitoring arm of the Radboud Tooth Wear Project, were taken at baseline and at 3 years (+/-10months). The occlusal/incisal surface of each tooth (excluding 3rd molars) was analysed for volume change and volume change per mm of analysed surface area in WearCompare (www.leedsdigitaldentistry.com/Wearcompare) following previously published protocols. Data were normal, descriptives and multi-level linear regression analysis was performed in Stata v15.1 taking patient level and surface type data into account. ResultsData from 556 surfaces in 29 patients were included in analysis. Per patient, mean volume loss (95 % CI) was -0.91mm3(-1.28,-0.53) on all surfaces, -1.85mm3(-2.83,-0.86) on index surfaces, -2.53mm3(-3.91,-1.15) on molar surfaces and -0.83 mm3(-1.34,-0.31) on upper central incisal surfaces. Statistical differences were observed between analysing all surfaces and index teeth(p = 0.002) in addition to molar surfaces(p < 0.0001). Mean volume loss per mm2 of surface analysed was -0.024 mm3 (-0.031,-0.017), -0.028mm3 (-0.041,-0.014), -0.030mm3 (-0.046,-0.013) and -0.025mm3 (-0.041,-0.010) for all surfaces, index surfaces, first molar surfaces and central incisor surfaces respectively with no statistical differences between groups. ConclusionsWear on upper central incisors was not statistically different to full arch wear analysis. If the surface area is standardised, wear on both index surfaces are statistically similar to wear on the full arch. Clinical SignificanceThese results suggest that analysing rates of wear on index teeth can be a resource-saving substitute for analysing rates of wear on the entire dentition, provided the surface area is standardised. If whole surfaces are analysed, the molar surfaces will show greater rates of wear.