Quantitative Evaluation of Ankle Instability Using a Capacitance-Type Strain Sensor

Abstract

Category:Basic Sciences/Biologics; Ankle; SportsIntroduction/Purpose:Manual evaluation is an important method for assessing ankle instability, but it is not quantitative. Capacitance-type sensors can be used to measure the distance on the basis of the capacitance value. We applied the sensor to the noninvasive device for measuring ankle instability and showed its utility.Methods:First, five ankles embalmed by Thiel's method were used in an experiment using a cadaver. The capacitance-type sensor was fixed alongside the anterior talofibular ligament (ATFL) of a specially made brace, and the anterior drawer test was performed. The test had been performed for the intact ankle, with the ATFL transected, and with both the ATFL and calcaneofibular ligament (CFL) transected. The anterior drawer distance was calculated by the sensor. Intra and interinvestigator reliability were also analyzed. Next, as a clinical study, a brace with a sensor was fitted to 22 ankles of 20 patients with a history of ankle sprain. An anterior drawer test at a load of 150 N was conducted using a Telos stress device. The anterior drawer distances measured by the sensor and based on X-ray images were then compared.Results:The mean anterior drawer distance for the intact cadavers was 3.7 +- 1.0 mm, 6.1 +- 1.6 mm with the ATFL transected (P < 0.001), and 7.9 +- 1.8 mm with the ATFL and CFL transected (P < 0.001). The intrainvestigator intraclass correlation coefficients (ICC) were 0.862-0.939, and the interinvestigator ICC was 0.815. In the experiments on patients, the mean anterior drawer distance measured by the sensor was 2.9 +- 0.9 mm and 2.7 +- 0.9 mm from the X-ray images. The correlation coefficient between the sensor and the X-ray images was 0.843.Conclusion:We carried out a quantitative evaluation of anterior drawer laxity using a capacitance-type sensor and found it had high reproducibility. It was also very strongly correlated with stress radiography measurements in patients with ankle instability. Capacitance-type sensors can be used for the safe, simple, and accurate evaluation of ankle instability.