Abstract
Background: A four-component system for urate transport in nephrons has been proposed and widely investigated by various investigators studying the mechanisms underlying urinary urate excretion. However, quantitative determinations of urate transport have not been clearly elucidated yet. Methods: The equation C<sub>ua</sub> = {C<sub>cr</sub>(1 – R<sub>1</sub>) + TSR}(1 – R<sub>2</sub>) was designed to approximate mathematically urate transport in nephrons, where R<sub>1</sub> = urate reabsorption ratio; R<sub>2</sub> = urate postsecretory reabsorption ratio; TSR = tubular secretion rate; C<sub>ua</sub> = urate clearance, and C<sub>cr</sub> = creatinine clearance . To investigate relationships between the three unknown variables (R<sub>1</sub>, R<sub>2</sub>, and TSR), this equation was expressed as contour lines of one unknown on a graph of the other two unknowns. Points at regular intervals on each contour line for the equation were projected onto a coordinate axis and the high-density regions corresponding to high-density intervals of a coordinate were investigated for three graph types. For benzbromarone (BBR)-loading C<sub>ua</sub> tests, C<sub>ua</sub> was determined before and after oral administration of 100 mg of BBR and C<sub>ua</sub>BBR(∞) was calculated from the ratio of C<sub>ua</sub>BBR(100)/C<sub>ua</sub>. Results: Before BBR administration, points satisfying the equation on the contour line for R<sub>1</sub> = 0.99 were highly dense in the region R<sub>2</sub> = 0.87–0.92 on all three graphs, corresponding to a TSR of 40–60 ml/min in hyperuricemia cases (HU). After BBR administration, the dense region was shifted in the direction of reductions in both R<sub>1</sub> and R<sub>2</sub>, but TSR was unchanged. Under the condition that R<sub>1</sub> = 1 and R<sub>2</sub> = 0, urate tubular secretion (UTS) was considered equivalent to calculated urinary urate excretion (U<sub>ex</sub>) in a model of intratubular urate flow with excess BBR; C<sub>ua</sub>BBR(∞) = TSR was deduced from the equation at R<sub>1</sub> = 1 and R<sub>2</sub> = 0. In addition, TSR of the point under the condition that R<sub>1</sub> = 1 and R<sub>2</sub> = 0 on the graph agreed with TSR for the dense region at excess BBR. TSR was thus considered approximately equivalent to C<sub>ua</sub>BBR(∞), which could be determined from a BBR-loading C<sub>ua</sub> test. Approximate values for urate glomerular filtration, urate reabsorption, UTS, urate postsecretory reabsorption (UR<sub>2</sub>), and U<sub>ex</sub> were calculated as 9,610; 9,510; 4,490; 4,150, and 440 µg/min for HU and 6,890; 6,820; 4,060; 3,610, and 520 µg/min for normal controls (NC), respectively. The most marked change in HU was the decrease in TSR (32.0%) compared to that in NC, but UTS did not decrease. Calculated intratubular urate contents were reduced more by higher UR<sub>2</sub> in HU than in NC. This enhanced difference resulted in a 15.4% decrease in U<sub>ex</sub> for HU. Conclusion: Increased UR<sub>2</sub> may represent the main cause of urate underexcretion in HU.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
