Quantitative Analysis of CO2 Evolution in an Alkaline Electrolyte Solution By Differential Electrochemical Mass Spectroscopy

Abstract

CO2 is involved in various main and side reactions of electrochemical energy devices, such as carbon corrosion reactions and alcohol oxidation reactions. Differential electrochemical mass spectroscopy (DEMS) has been intensively applied in acidic electrolyte solutions to analyze these reactions. DEMS is the in-situ electrochemical measurement technique to analyze volatile species with the mass spectrometer (MS). However, the applications of DEMS to alkaline electrolyte solutions have been limited due to the high solubility of CO2 in alkaline solutions. While "conventional DEMS cells," where porous thin-film working electrodes are formed onto polytetrafluoroethylene (PTFE) membrane interface, can quantitatively analyze CO2 that has not dissolved into the electrolyte yet [1], the working electrode materials are limited to those that can be deposited on porous PTFE membrane as porous thin-films. Recently, Möller et al. have developed the DEMS system, which can detect CO2 from general planer electrodes coated by catalyst powders by combining a neutralizer and "dual thin-layer flow cell" [2]. However, due to the relatively low detection limit, quantitative analysis of evolved CO2 has not been accomplished. In this study, we attempt to use high surface area electrodes to enhance the MS signal of CO2 to enable quantitative analysis of evolved CO2. To suppress the in-plane reaction distribution in the flow cell, we integrated an anion exchange membrane into the cell and arranged the counter electrode opposing the working electrode [3] (Fig. 1 (a)).CO-stripping voltammetry was performed to evaluate the CO2 detectability of the constructed DEMS system. The DEMS cell was composed of a commercial Pt/C electrode as the working electrode, a commercial Hg/HgO electrode as the reference electrode, a Pt mesh as the reference electrode, 1 mol dm–3 KOH aq as the electrolyte solution, and 1 mol dm–3 H2SO4 aq as the neutralizer. Figure 1 (b) shows the CO-stripping voltammogram and corresponding MS signal of CO2 (m/z = 44). MS signal of CO2 accompanied by the anodic CO oxidation current is clearly observed from 0.6 to 1.2 V vs. RHE. The calibration constant, which correlates the MS signal of CO2 to partial current for CO2 evolution reaction, is successfully obtained as 2.2 × 10–10, which shows that the DEMS system established in this study can quantitatively analyze CO2. Applications to the carbon corrosion reactions are also presented at the site.