Abstract

Base flow, as an important component of runoff, is the main recharge source of runoff during the dry period, especially in the Yellow River Basin located in a semiarid area. However, the process of obtaining base flow has great uncertainty when considering hydrological simulations. Thus, in this study, a three-step framework is proposed, i.e., the particle swarm optimization (PSO) algorithm is used to calibrate model parameters under different subbasin partitioning schemes; then, the hydrograph separation (HYSEP), Improved United Kingdom Institute of Hydrology (IUKIH) and Lyne and Hollick filter (Lyne-Hollick) methods are used to separate the baseflow from the total runoff process, thereby exploring the uncertainty impacts of baseflow segmentation methods on the hydrological simulation process. The subsample-variance-decomposition method is used to quantify the independent and interactive uncertainty in the hydrological simulation process. The results show that the Topmodel model can be better applied to the source area of the Yellow River (the KGE values in the Sub5, Sub13, Sub21, Sub29, Sub37 and Sub13 scenarios were 0.91 and 0.65, 0.94 and 0.86, 0.94 and 0.88, 0.92 and 0.82, 0.95 and 0.89, and 0.92 and 0.83, respectively). The subbasin division uncertainty had less impact on simulated streamflow during the dry season and had a significant impact in the wet season, such as, the subbasin division uncertainty caused the difference between the median of the simulated streamflow to be as high as 213.09 m3/s in August but only 107.19 m3/s in January; Meanwhile, the baseflow segmentation method uncertainty has a significant impact on the annual mean streamflow values under different subbasin segmentation schemes. In addition, the baseflow values estimated by the Lyne-Hollick and HYSEP methods were obviously higher than those estimated by the IUKIH method during the wet season. The uncertainty influence of subbasin partitioning schemes and baseflow segmentation methods had significant differences on hydrological processes in different periods. The uncertainty influence of subbasin partitioning schemes was dominant in the dry season, accounting for 86%, and the baseflow segmentation methods took second place, accounting for approximately 12%. In the wet season, the uncertainty influence of the baseflow segmentation methods was gradually weakened, which may have been due to the uncertainty influence of the hydrological model. These results provide a reference for the calibration and validation of hydrological model parameters using baseflow components.

Highlights

  • The results show that the Topmodel model can be better applied to the source area of the Yellow River

  • Rouhani et al employed baseflow, which was obtained by using the partial duration series approach, to calibrate and validate the Soil and Water Assessment Tool (SWAT) model [19]

  • Hydrological models play an important role in simulating hydrological processes of a watershed, and the basic steps for successfully constructing a hydrological model are dividing a catchment basin into different subbasin response units and calibrating and validating the hydrological model parameters

Read more

Summary

Introduction

Climate change and high-intensity human activities accelerate the hydrological cycle. Distributed, semidistributed or lumped units indicates a critical way to differentiate hydrological models, as this is closely related to the scale at which the input variables are considered homogeneous. Watershed partitioning is widely used in semidistributed hydrological models to consider spatial heterogeneities in different areas within watersheds. Many studies have been conducted by investigating the influence of watershed partitioning schemes on the model results of different hydrological models [3–5]. Several studies have discussed the influence of watershed partitioning schemes on the accuracy of hydrological simulations [6, 7]. Han et al analyzed the influence of eight watershed partitioning schemes on SLURP hydrological simulations in the Xiangxi River Basin [9]. Jha et al used the Soil and Water Assessment Tool (SWAT) model to determine the appropriate level of watershed partitioning for simulating flow, sediment, and nutrients over 30 years in four Iowa watersheds [10]

Objectives
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call