Quantification of Shear Stresses Within a Transtibial Prosthetic Socket.

Abstract

There is a paucity of objectively recorded data delineating the pattern of weightbearing distribution within the prosthetic socket of patients with transtibial amputation. Our current knowledge is based primarily on information obtained from finite element analysis computer models. Four high-functioning transtibial amputees were fit with similar custom prosthetic sockets. Three load cells were incorporated into each socket at high stress contact areas predicted by computer modeling. Dynamic recording of prosthetic socket loading was accomplished during rising from a sitting position, stepping from a 2-leg stance to a 1-leg stance, and during the initiation of walking. By comparing the loads measured at each of the 3 critical locations, anterior/posterior shear, superior/inferior shear, and end weightbearing were recorded. The same load pattern in all 4 subjects was found during each of the 3 functional activities. The load transmission at the distal end of the amputation residual limbs was negligible. Consistent forces were observed in both the anterior/posterior and superior/inferior planes. Correlation coefficients were used to compare the loads measured in each of the 4 subjects, which ranged from a low of .82 to a high of .98, where a value approaching 1.0 implies a linear relationship amongst subjects. This experimental model appears to have accurately recorded loading within a transtibial prosthetic socket consistent with previously reported finite element analysis computer models. This clinical model will allow objective measurement of weightbearing within the prosthetic socket of transtibial amputees and allow objective comparison of weightbearing distribution within the prosthetic sockets of patients who have undergone creation of different versions of a transtibial amputation residual limb and prosthetic socket designs.