Abstract

Abstract. Knowledge of calcium phosphate (Ca-P) solubility is crucial for understanding temporal and spatial variations of phosphorus (P) concentrations in water bodies and sedimentary reservoirs. In situ relationships between liquid- and solid-phase levels cannot be fully explained by dissolved analytes alone and need to be verified by determining particular sediment P species. Lack of quantification methods for these species limits the knowledge of the P cycle. To address this issue, we (i) optimized a specifically developed conversion–extraction (CONVEX) method for P species quantification using standard additions, and (ii) simultaneously determined solubilities of Ca-P standards by measuring their pH-dependent contents in the sediment matrix. Ca-P minerals including various carbonate fluorapatite (CFAP) specimens from different localities, fluorapatite (FAP), fish bone apatite, synthetic hydroxylapatite (HAP) and octacalcium phosphate (OCP) were characterized by XRD, Raman, FTIR and elemental analysis. Sediment samples were incubated with and without these reference minerals and then sequentially extracted to quantify Ca-P species by their differential dissolution at pH values between 3 and 8. The quantification of solid-phase phosphates at varying pH revealed solubilities in the following order: OCP > HAP > CFAP (4.5% CO3) > CFAP (3.4% CO3) > CFAP (2.2% CO3) > FAP. Thus, CFAP was less soluble in sediment than HAP, and CFAP solubility increased with carbonate content. Unspiked sediment analyses together with standard addition analyses indicated consistent differential dissolution of natural sediment species vs. added reference species and therefore verified the applicability of the CONVEX method in separately determining the most prevalent Ca-P minerals. We found surprisingly high OCP contents in the coastal sediments analyzed, which supports the hypothesis of apatite formation by an OCP precursor mechanism.

Highlights

  • Phosphorus cycles are influenced by P concentration and composition in both the liquid and solid phase

  • Provided dissolved inorganic P (DIP) levels are controlled by these mechanisms, P minerals may be qualitatively determined in natural (Avnimelech, 1983; Bray et al, 1973; Emerson and Widmer, 1978; Gaudette and Lyons, 1980) or experimental (Murrmann and Peech, 1969; Oxmann et al, 2008) environments using appropriate dissociation constants and apparent solubility products allowing for ionic strength effects and ion-pairing

  • Octacalcium phosphate dissolved within a narrow pH range above pH 7, carbonate fluorapatite (CFAP) within a large pH interval of ca. 3.5–7 and FAP within a small pH range below pH 3.5

Read more

Summary

Introduction

Phosphorus cycles are influenced by P concentration and composition in both the liquid and solid phase. Non-equilibrium behaviour is typical for natural systems (Carman and Rahm, 1997), precipitation and dissolution mechanisms may occasionally attain equilibrium between certain P minerals and dissolved inorganic P (DIP). Provided DIP levels are controlled by these mechanisms, P minerals may be qualitatively determined in natural (Avnimelech, 1983; Bray et al, 1973; Emerson and Widmer, 1978; Gaudette and Lyons, 1980) or experimental (Murrmann and Peech, 1969; Oxmann et al, 2008) environments using appropriate dissociation constants and apparent solubility products allowing for ionic strength effects and ion-pairing. Whether adsorption effects or mineral formation and dissolution influence soluble P concentrations depends largely on sediment types and physical–chemical conditions.

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call