Abstract

Precipitation use efficiency (PUE) was estimated for four production practices, i.e. conventional tillage with November planting (CTN), conventional tillage with January planting (CTJ), in-field rainwater harvesting with November planting (WHBN), and in-field rainwater harvesting with January planting (WHBJ), over 80 maize seasons for a semi-arid ecotope in the central Free State Province of South Africa. An empirical yield prediction model was used to obtain maize grain yields. PUE was expressed as the ratio of transpiration: rainfall for each growing season (PUET), while transpiration was calculated from total biomass yield, vapour pressure deficit and a transpiration efficiency coefficient for maize. The following equation, based on 10 years of measured data, was developed to estimate daily vapour deficit pressure for the 80 seasons from daily maximum temperature: Vd = 0.163 x Tmax – 2.88 (R2 = 0. 73). Mean PUET values over the 80 seasons were: 0.260 for CTN, 0.320 for WHBN, 0.334 for CTJ, and 0.400 for WHBJ. These results confirmed and quantified the advantage of in-field rainwater harvesting over conventional tillage, and the advantage of January planting over November planting. PUET results were also expressed as cumulative probability functions. Significance tests showed that PUET for in-field rainwater harvesting was significantly better than PUET for conventional tillage, and that January planting was significantly better than November planting. It was concluded that the advantage of in-field rainwater harvesting over conventional tillage was mainly due to the absence of runoff and reduced evaporation in the former practice. The use of a short-growing cultivar, which flowers during the month with the most favourable climate, i.e. March, probably resulted in the advantage of January planting over November planting.

Highlights

  • Water availability is the most important limiting factor for rainfed crop production in semi-arid areas

  • Significance tests showed that PUET for in-field rainwater harvesting was significantly better than PUET for conventional tillage, and that January planting was significantly better than November planting

  • (i) November planting with conventional tillage (CTN) (ii) November planting with in-field rainwater harvesting (WHBN) (iii) January planting with conventional tillage (CTJ) (iv) January planting with in-field rainwater harvesting (WHBJ)

Read more

Summary

Introduction

Water availability is the most important limiting factor for rainfed crop production in semi-arid areas. Maximising precipitation use efficiency (PUE) is important This can be achieved by identifying and employing the crop production practice with the highest PUE for that specific ecotope. Valuable in certain cases, WUE does not enable the comparison of different production practices This is because certain water loss processes, which can be minimised by using suitable water conservation tillage (WCT) practices to improve the efficiency of rainwater use in crop production, are not taken into account. These losses include runoff, evaporation and deep drainage, during the growing and fallow seasons. Precipitation use efficiency (PUEY) is considered to be a more appropriate parameter to describe the overall efficiency with which rainwater is used in rain-fed cropping, since the named losses are taken into account (Hensley et al, 1990): PUEY where: PUEY

Objectives
Methods
Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.