QTT Ultra-wideband Signal Acquisition and Baseband Data Recording System Design Based on the RFSoC Platform

Abstract

Abstract The 110 m QiTai radio Telescope (QTT) will be equipped with multiple Ultra-WideBand (UWB) receivers in the primary and Gregory focus to achieve continuous frequency coverage from 270 MHz to 115 GHz, which poses great challenges to signal acquisition, transmission, and real-time processing. Aiming at 10 GHz and above full-bandwidth acquisition and multi-scientific processing for the QTT UWB signals, an experimental system with high-speed signal acquisition, 100 Gb network multi-path distribution, and fast recording is designed by using advanced direct RF-sampling technology and heterogeneous architecture. The system employs a ZCU111 board to digitize dual-polarization signals with a sampling rate of 4.096 GigaSamples-Per-Second and 12-bit quantization. The collected wideband signals are channelized into 2048 chunks, which are then assembled into 16 sets of digital narrow basebands with 128 MHz bandwidth and transmitted to the processing servers through two 100 Gb ports. A HASPIPE pipeline, UWB_HASHPIPE is designed to receive and store multiple subbands in parallel. Data distribution links can be flexibly configured based on IP addresses and port numbers. The system is verified by pulsar observation experiments on the Nanshan 26 m telescope. 512 MHz bandwidth is selected from the collected L-band receiver signals and recorded in VDIF file format with 8 parallel instances. The test results show that the data integrity is excellent, and the signal-to-noise ratio of the band-merged pulsar profile is stronger than single subband data. This paper provides a high-performance and flexible solution for the design of versatile UWB backends. Meanwhile, the developed platform can be integrated into QTT backends for baseband data collection and Very Long Baseline Interferometry observation.