Abstract
The pyrophoricity of Cu/ZnO-based and Pt-based catalysts was studied during oxidative shut-down/start-up of the low-temperature water-gas shift (LT-WGS) reaction to assess whether these catalysts are suitable for fuel cell application. The Cu/ZnO-based catalysts were observed to display high levels of pyrophoricity manifested as a sharp temperature rise of the catalyst bed upon air introduction. This promoted severe sintering of the bulk and metallic phases of the catalyst facilitating catalyst deactivation. No pyrophoricity was observed for any of the Pt-based catalysts; however, sintering of the metallic phase in Pt/TiO 2 and Pt/ZrO 2 persisted, leading to a decrease in activity. It was likely that the sintering of Pt occurred during LT-WGS operation itself. In contrast, Pt/CeO 2 was the only catalyst which retained its activity, displaying no loss in specific surface area or metal dispersion throughout the entire process making it the most suitable candidate of the materials investigated for fuel cell systems. Temperature-programmed oxidation studies indicated deactivation by the oxidative shut-down/start-up operation did not result from the build-up of carbonaceous species.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.