Abstract
This paper introduces a push-pull class-EM power amplifier for achieving low harmonic contents and high output power. By applying the push-pull configuration of the class-EM power amplifier, the proposed amplifier achieves an extremely lower total harmonic distortion (THD) and about four times higher output power than the conventional single class-EM power amplifier. Design curves of the proposed amplifiers for satisfying the class-EM ZVS/ZDVS/ZCS/ZDCS conditions are given. A design example is shown along with the PSpice-simulation and experimental waveforms for 1-MHz amplifier, considering the MOSFET drain-to-source nonlinear parasitic capacitances, MOSFET switch-on resistances, and equivalent series resistance of the inductors. The waveforms from the PSpice simulation and circuit experiment satisfied all the switching conditions, which has shown the accuracy of the design curves given in this paper and validated the effectiveness of the push-pull class-EM power amplifier.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Circuits and Systems I: Regular Papers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
