Purification and Properties of a Thermophilic Bacteriophage Lytic Enzyme

Abstract

A phage lytic enzyme was isolated from lysates of Bacillus stearothermophilus (NCA 1503-4R). The enzyme was purified 1,998-fold with a 27% recovery of enzyme activity. By use of polyacrylamide gel electrophoresis and sucrose gradient centrifugation the enzyme was judged free from protein contaminants. The lytic enzyme was active over a pH range of 6.0 to 7.0, with a maximum at 6.3, and it was stable between pH 7.0 and 8.0 and at 5.0 and unstable between pH 5.5 and 6.5. The temperature coefficient (Q(10)) was 2.27 between 35 and 45 C, 2.01 between 45 and 55 C, and 2.00 between 50 and 60 C. Lytic enzyme in 0.1 m sodium phosphate was not inactivated after a 1-hr exposure to temperatures below 65.5 C, whereas a 1% inactivation was observed at 70.6 C. A 2-hr exposure at 60.1, 65.5, and 70.6 C resulted in an inactivation of 1.2, 9.6, and 12.0%, respectively. A sodium phosphate concentration of at least 0.1 m was necessary for the prolonged exposure of lytic enzyme at 55 C (pH 6.3), whereas 0.005 m was required for maximal lytic activity. Lytic activity was stimulated 169, 165, and 160% by 10(-4)m Mg(++), Ca(++), and Mn(++), respectively. Lytic activity was inhibited 75% by 10(-4)m ethylenediaminetetraacetic acid (EDTA). The EDTA inhibition could be reversed by the addition of excess Mg(++), Ca(++), or Mn(++). Lytic activity was not affected by NaCl, KCl, or NH(4)Cl. Lytic activity was inhibited 100, 91, 25, 61, and 56% by 10(-4)m Hg(++), Cu(++), Zn(++), p-chloromercuribenzoate, and p-hydroxymercuribenzoate, respectively. Cysteine or 2-mercaptoethanol did not stimulate lytic activity, nor were these sulfhydryl compounds required for maintenance of enzyme activity during handling or storage. Cell walls were rapidly solubilized when incubated with lytic enzyme. Lytic action was complete after 1.5 min, with a 70% reduction in optical density (OD). Cell walls without lytic enzyme showed no reduction in OD during this period. The solubilization of N-terminal amino groups paralleled the reduction in OD and reached a level of 0.3 mumole/mg of cell wall after 4 min of incubation. Cell walls with and without lytic enzyme treatment showed a 3- and a 1.3-fold increase, respectively, in N-terminal amino groups after 3 hr of incubation. There was no release of reducing power in either the untreated cell wall suspensions or those treated with lytic enzyme. Electron micrographs of treated and untreated cell walls showed that the enzyme partially degrades the cell wall with the release of small wall fragments.