Abstract
Summary Three pump-intake-pressure (PIP) calculation methods available for wells artificially lifted with sucker rods are discussed in detail in this paper. The values of PIP obtained from acoustic fluid-level measurements in wells with moderate pump submergence can yield PIP estimates that agree with those of pump fluid-load analysis. If PIPs determined using these methods do not agree, then the operator must review the data quality and may reduce the deviation by adjusting certain parameters affecting the calculations. Field data for a significant group of wells are used to compare the PIP results of the three methods. The results show that the PIP computed using the maximum and minimum pump dynamometer loads usually calculates a PIP that is too low, while the PIPs computed using the valve test loads are usually too high. Recommendations are presented for quality control of the computed values.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
