Pt(IV)-ion imprinted ordered mesoporous organosilica for platinum preconcentration prior to electrothermal atomic absorption spectrometry determination in geological samples

Abstract

Pt(IV) ion-imprinted thiocyanato-functionalized SBA-15 material (Pt(IV)S1) was proposed for preconcentration of Pt(IV) ions from digested geological samples before its electrothermal atomic absorption spectrometry (ETAAS) determination. The ion-imprinted material exhibited very good adsorption affinity towards Pt(IV) ions. Under the optimal pH (pH = 3) the maximum static adsorption capacity for Pt(IV) was equal to 175 mg g−1. The use of Pt(IV)S1 as an adsorbent allowed for the quantitative adsorption of Pt(IV) ions from solutions with concentrations up to 25 mg L−1. The creation of ion imprinted adsorption centres resulted in an increase of the adsorption rate and selectivity towards Pt(IV) compared to the similar non-ion imprinted material. The analytical procedure was based on the adsorption of Pt(IV) ions and dissolution of the Pt-loaded sorbent in a small volume of hydrofluoric acid before its dilution with 5% hydrochloric acid and introduction into an electrothermal atomizer. The enrichment factor of the proposed procedure was 38, while the limit of quantification was 0.079 mg kg−1.