Abstract
Pt(IV) ion-imprinted thiocyanato-functionalized SBA-15 material (Pt(IV)S1) was proposed for preconcentration of Pt(IV) ions from digested geological samples before its electrothermal atomic absorption spectrometry (ETAAS) determination. The ion-imprinted material exhibited very good adsorption affinity towards Pt(IV) ions. Under the optimal pH (pH = 3) the maximum static adsorption capacity for Pt(IV) was equal to 175 mg g−1. The use of Pt(IV)S1 as an adsorbent allowed for the quantitative adsorption of Pt(IV) ions from solutions with concentrations up to 25 mg L−1. The creation of ion imprinted adsorption centres resulted in an increase of the adsorption rate and selectivity towards Pt(IV) compared to the similar non-ion imprinted material. The analytical procedure was based on the adsorption of Pt(IV) ions and dissolution of the Pt-loaded sorbent in a small volume of hydrofluoric acid before its dilution with 5% hydrochloric acid and introduction into an electrothermal atomizer. The enrichment factor of the proposed procedure was 38, while the limit of quantification was 0.079 mg kg−1.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
