Pseudohyperchloremia and Negative Anion Gap – Think Salicylate!

Abstract

BackgroundPseudohyperchloremia results in a very low or negative anion gap. Historically, the most common cause of this artifact was bromide poisoning. Bromide salts have been removed from most medications and bromism has become very uncommon. More recently, the introduction of chloride ion selective sensing electrodes (Cl-ISE) has generated a new cause of pseudohyperchloremia—salicylate poisoning. We describe 5 such patients and quantitate the error generated by this measurement artifact. MethodsThe magnitude of artifactual hyperchloremia generated by high salicylate levels was quantified in 5 patients by measuring chloride concentration with several Cl-ISEs from different manufacturers and with Cl-ISEs of different “ages,” and comparing these results to measurements with a chloridometer (coulometric titration), which is free of the salicylate artifact. ResultsCl-ISEs from different manufacturers generated a wide range of artifactual chloride concentration elevation. Furthermore, the same Cl-ISE generated increasingly severe pseudohyperchloremia as it was repeatedly reused over time and “aged.” ConclusionsSalicylate interferes with measurement of the blood chloride concentration when a Cl-ISE is used. The severity of this artifact is related to the salicylate level, the specific Cl-ISE, and the “age” of the electrode. Toxic blood salicylate levels can generate marked pseudohyperchloremia, and consequently, an artifactual very small or negative anion gap. The large anion gap metabolic acidosis typical of salicylate poisoning is masked by this artifact. Salicylate has become the most common cause of pseudohyperchloremia, and physicians should immediately consider salicylate poisoning whenever the combination of hyperchloremia and a very small or negative anion gap is reported by the laboratory.