Protective properties of organic phosphate-pigmented coatings on phosphated steel substrates

Abstract

Investigations have been carried out on properties of coatings, differing by their pigmentation and binder, and applied on different chemical pre-treatments of the steel surface. Paints based on alkyd and alkyd-melamine binders, pigmented with zinc phosphate and modified basic zinc phosphate were applied on amorphous and crystalline phosphated steel surface and, for the comparison purpose, on degreased steel surface. The effect of the binder, the pigment and the pre-treatment of the steel surface on the protective properties of the coatings were determined by measurements of adhesion, water absorption and water permeability and by results obtained in salt spray and Prohesion tests. Coatings based on alkyd binder show a lower damage degree and good retention of adhesion in corrosion conditions, in spite of a higher water absorption and water permeability and a lower initial adhesive strength. Protective properties of coatings have been found to be highly dependent upon the substrate pre-treatment. Chemical pre-treatment of the steel substrate increases the protective properties of the system, which is particularly evident in the case of crystalline phosphating and the coating pigmented with modified basic zinc phosphate. This phenomenon can be explained by the synergism between this phosphate pigment with crystalline phosphate layer.