Protection Level and Reusability of a Modified Full-Face Snorkel Mask as Alternative Personal Protective Equipment for Healthcare Workers during the COVID-19 Pandemic.

Abstract

The worldwide outbreak of COVID-19 has drastically increased pressure on medical resources and highlighted the need for rapidly available, large-scale, and low-cost personal protective equipment (PPE). In this work, an alternative full-face mask is adapted from a modified snorkel mask to be used as PPE with two medical-grade filters and a 3D-printed adapter. Since the mask covers the eyes, mouth, and nose, it acts as a full-face shield, providing additional protection to healthcare workers. The SARS-CoV-2 has a size between 60 nm and 140 nm, and airborne viral particles can be carried by larger droplets with sizes up to several millimeters. The minimum filtration efficiency of mechanical and electrostatic filters is usually reached between 30 nm and 300 nm. The filtration efficiency of different medical filters is measured for particles below 300 nm to cover the size of the SARS-CoV-2 and small virus-laden droplets, and determine the minimum efficiency. The filtration performance of the adapted full-face mask is characterized using NaCl particles below 500 nm and different fitting scenarios to determine the minimum protection efficiency. The mask is compared to a commercial respirator and characterized according to the EN 149 standard, demonstrating that the protection fulfills the requirements for the FFP2 level (filtering face-piece 2, stopping at least 94% of airborne particles). The device shows a good resistance to several cycles of decontamination (autoclaving and ethanol immersion), is easy to be produced locally at low cost, and helps to address the shortage in FFP2 masks and face shields by providing adequate protection to healthcare workers against particles <500 nm in size.