Protecting Consumer Health by Developing an Electrochemical Immunosensor for the Detection of Banned Antibiotic Residues in Honey

Abstract

IntroductionChemical (eg pesticides, veterinary drugs, etc.) and bacteriological contaminants (eg. foodborne pathogens) could contaminate animal and plant derived food products for human consumption. Some antibiotic residues (eg. chloramphenicol, nitrofuran metabolites, dyes) are banned in foodstuffs of animal origin (eg. milk, meat, eggs, etc.) in European Union because of toxicological risks for the consumer. The European Regulation has set Minimum Required Performance Limits (MRPL) [1] or Reference Point for Action (RPA) for banned substances [2]. Food containing residues of substances at or above the MRPL or RPA are declared non-compliant and consignments are rejected from the consumer's market.Screening methods are the first stage of food control and so are essential for food safety monitoring. Conventional screening methods are microbiological methods (eg. plate tests, tube tests), immunological methods (eg. ELISA, radioimmunoassays) or physico-chemical methods (Thin Layer Chromatography, High Performance Liquid Chromatography (HPLC), liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS)). These methods sometimes lack of sensitivity or specificity; they also could be time and money consuming. There is thus a need to develop novel screening methods for antibiotic residues detection, preferably with the potential for the field-testing (eg. farm control, self-control). Electrochemical biosensors make it possible to develop a promising and economically interesting approach.Electrochemical immunosensorAn innovative electrochemical method based on disposable Screen Printed Carbon Electrodes (SPCE), coupled to magnetic beads (MB), allowing the simultaneous detection of 3 families of antibiotics in milk, was published by a Spanish academic team [3]. This technique presents major advantages: low cost (eg. disposable electrodes, potentiostat), promising detection limits, portability, and possible automatisation. Our laboratory has evaluated the transferability of the method. An electrochemical immunosensor has been developed for the detection of chloramphenicol residues in honey as a proof of concept. Honey composition and colour varies considerably depending on the botanical origin. Moreover some honey ingredients can interfere with the electrochemical detection, especially substances with antioxidant activities (eg. polyphenols). Therefore a lot of work had to be done to improve sample extraction to reduce matrix effects.The objective is to develop an electrochemical bead-based immunosensor for the multiplex detection of banned antibiotics (eg. chloramphenicol, nitrofuran metabolites, dyes) in bovine milk.MethodAntibodies (Abs) against antibiotics are grafted on the surface of magnetic beads (MBs). Milk samples and antibiotic conjugated with Horseradish peroxidase (HRP) are mixed with MBs-Abs. A competition occurs between the HRP conjugates and the antibiotic residues if present in the sample, for the binding to the antibody. The MBs are washed to remove free antibiotics and conjugates. Then, a Screen Printed Carbon Electrode (SPCE) with MBs on its surface (maintained by a magnet) is soaked into a buffer solution containing hydroquinone; when adding hydrogen peroxide (H2O2) to the solution, an electrochemical signal is produced, due to the enzymatic activity of HRP and measured. The electrochemical signal is inversely proportional to the antibiotic concentration in the sample.Results and ConclusionsScreening methods for the detection of veterinary drugs in food products have to be validated according to the European regulation [1] and to the European guideline for the validation of screening methods [4]. After the development and the optimization of the analytical parameters (eg. sample preparation, HRP concentration, incubation time, applied potential, etc), the methods developed for single compounds will be evaluated and validated according to the European regulations. Then the single compound methods will be merged into one multiplex method if possible. The results will be presented to the conference, discussing the advantages and drawbacks of electrochemical biosensors for the screening of antibiotic residues in food products.