Abstract
The future satellite communication systems are required to support the higher transmission data rate for providing multimedia services by employing the efficient modulation method such as multilevel QAM. However, the employment of conventional single carrier transmission method with multi-level QAM which has larger PAPR (Peak to Averaged Power Ratio) would cause the fatal degradation of signal quality due to the non-linear amplifiers located at the earth station and satellite. To overcome this problem, this paper proposes broadband satellite communication systems by using the multilevel QAM-OFDM technique with IDAR (Improved Decision Aided Reconstruction) method, which is designed for satellite channel. In the IDAR method, the characteristics of non-linear amplifiers are required to be known at the receiver for mitigating the intermodulation noise. This paper also proposes the estimation method for AM-AM and AM-PM conversion characteristics of non-linear amplifiers by using low PAPR preamble symbols. The various computer simulations are conducted in this paper to verify the effectiveness of proposed system in the non-linear satellite channel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: ECTI Transactions on Computer and Information Technology (ECTI-CIT)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
