Abstract
The X80 girth welds were produced by solid-wire gas metal arc welding (GMAW) and shield metal arc welding (SMAW) using two welding consumables respectively, which contained different mass fraction of C, Mo and Ni. The tensile properties, notch toughness, hardness, and microstructures of welded joints were evaluated. The results indicate that high strength and good toughness of welded joints can be achieved. But the tensile properties of all weld metal of GMAW and SMAW process were evidently different because of the difference of mass fraction of C, Mo, Ni. The strength reduced slightly in softening zone of HAZ. Using welding consumable which contain higher Mo additions, the microstructure in filler weld and fusion zones were IAF+GB and GB+M respectively. Furthermore, the mechanical properties of X80 pipeline welded by single wire welding and double wire welding respectively have been compared. The double wire welds exhibited lower yield strength but higher toughness compared to the corresponding single wire welds.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
