Properties of Mn3O4 thin film electrodes prepared using spray pyrolysis for supercapacitor application

Abstract

Film electrodes are made by depositing a thin layer of an electroactive material onto a conductive substrate. The performance of thin film electrodes in energy storage devices is significantly governed by their preparative conditions, particularly the molar concentration of the initial precursor. In the current study, the preparation of Mn3O4 thin film electrodes utilizing the chemical spray pyrolysis technique is discussed. The effect of molar concentration on the structural, morphological, and electrochemical properties of the thin film electrodes was thoroughly investigated using techniques including X-ray diffraction (XRD), Raman spectroscopy, scanning electron microscopy (SEM), atomic force microscopy (AFM), electrochemical impedance spectroscopy (EIS), cyclic voltammetry (CV) and galvanostatic charge/discharge (GCD) studies. Additionally, X-ray photoelectron spectroscopy (XPS) was employed to gain more insight into the oxidation states of the sample with the best electrochemical performance. Findings suggested that the molar concentration considerably affects the crystallite size, surface area, surface roughness, and wettability, which would directly impact the functionality of the electrode. It was concluded that the electrode deposited using the molar concentration of 0.06 M showed significantly improved performance according to the electrochemical measurements. The areal capacitance of up to 105.3 mF/cm2 in the aqueous electrolyte was recorded from CV measurements at a scan rate of 5 mVs−1. These electrodes could be an option for low-cost, environmentally friendly electrochemical capacitors if prepared under optimal deposition conditions.