Abstract
The study discussed in the article aimed to identify the obtainability of a gradient layer made by the High-Velocity Oxygen Fuel (HVOF)-spraying of an NiAl-based coating between a layer made using the plasma cladding process and powder Stellite 6 and a substrate made of structural steel S355JR. Overlay welds obtained in related tests were made using various process parameters as well as various values of current, travel speeds and powder feed rates. The study also involved the performance of macro and microscopic metallographic tests, hardness measurements as well as the analysis of the chemical and phase composition of gradient layers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.