Abstract
Fresh fracture surfaces formed by tensile failure of craze in molded polystyrene (PS) bars have been compared with the molded surfaces of the same bars, using an atomic force microscope with a thermal probe and operated in local thermal analysis. The results indicate that molecular weight is much higher in the interior of the sample than at the surface. No evidence was found for degradation of the PS chains via chain scission during crazing. Alternative explanations for the low-molecular weights at the molded surface are discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Polymer Science Part B: Polymer Physics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
