Abstract
One of the problems dealing with oil palm stem (OPS) plywood is the high veneer surface roughness that results in high resin consumption during the plywood manufacturing. In this study, evaluation was done on the effects of pretreatment of OPS veneers with phenol-formaldehyde resin on the bond integrity and bending strength of OPS plywood. OPS veneers were soaked in low molecular weight phenol-formaldehyde resin (LMW PF) for 20 seconds to obtain certain percentage of resin weight gain. OPS plywoods were produced using two types of lay-ups (100% outer veneer type and 100% inner veneer type) and two urea-formaldehyde (UF) adhesive spread amounts (200 g/m2 and 250 g/m2). The results show that pretreating the veneer with LMW PF could reduce the penetration of the adhesive into the fibres during gluing step. UF adhesive spread amount of 200 g/m2 is sufficient to produce good quality OPS plywood. The technique used in this study was able to enhance the mechanical properties of OPS plywood as well as reduce the amount of resin consumption.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
